Figure 4. Positioning a datum point a specified distance from two edges.
Enter parameter
Select an edge on the model, and enter the location of the datum point in the form of a
parameter value that represents a percentage of the edge length. An arrow along the edge
indicates the direction of increasing parameter value from the start vertex
(corresponding to an edge parameter value of zero) to the end vertex (corresponding to a
value of one), as shown in Figure 5. For
detailed instructions, see Creating a datum point by entering an edge parameter.
Figure 5. Positioning a datum point a specified distance along an edge.
Project point on face/plane
Select a point and a face or plane on which to project the point. Abaqus/CAE creates the datum point where the face or plane intersects a line that is normal to
it and passing through the selected point, as shown in Figure 6. The
datum point also marks the shortest distance between the selected point and the selected
face or plane. For detailed instructions, see Creating a datum point by projecting a point on a face or plane.
Figure 6. Creating a datum point by projecting a point onto a face.
Project point on edge/datum axis
Select a point on the model and an edge or datum axis on which to project the point.
Abaqus/CAE creates the datum point where the edge or datum axis intersects a line that is normal
to it and passing through the selected point, as shown in Figure 7. The
datum point also marks the shortest distance between the selected point and the selected
edge or datum axis. For detailed instructions, see Creating a datum point by projecting a point on an edge or datum axis.
Figure 7. Creating a datum point by projecting a point onto an edge.
Intersection of line and plane
Select a linear edge or datum axis and a planar face or datum plane on the model. Abaqus/CAE creates the datum point at the location where the line intersects with the plane, as
shown in Figure 8. For detailed instructions, see Creating a datum point by intersecting a line and a plane.
Figure 8. Creating a datum point by intersecting a line and a plane.
Offset from point in a direction
Select a point on the model to offset; select a linear edge or datum axis on the model
to act as the offset direction, and enter the offset distance. Abaqus/CAE creates the datum point by offsetting the point in the given direction, by the given
distance, as shown in Figure 9. For detailed instructions,
see Creating a datum point by offsetting a point along a direction.
Figure 9. Creating a datum point by offsetting a point along a direction.