Creating a datum point by intersecting a line and a plane
You can position a datum point by selecting a linear edge and a planar face or a
datum plane on the model. Abaqus/CAE creates the datum point at the location where the line intersects with the plane.
The figure below shows an example of creating a datum point by intersecting a line and a
plane.
From the main menu bar,
selectToolsDatum.
The Create Datum dialog box appears. The dialog box outlines the
types of datum geometry you can create.
Abaqus/CAE displays prompts
in the prompt area to guide you through the procedure.
Tip:
You can also create a datum point using the tool, located in the module toolbox. For a diagram of the datum tools
in the toolbox, see Using the Datum toolset.
From the list of types at the top of the dialog box, choose Point.
The Method list indicates the methods you can use to create a
datum point.
From the Method list, select Intersection of line and
plane.
If desired, select Make Independent from the prompt area to create
the datum as an independent feature.
From the part or assembly in the current viewport, select a linear edge/datum axis.
Select a planar face or a datum plane to intersect the selected line.
The datum point appears. You cannot modify a datum point created with this method; you
must delete the old point and create a new one.