Creating a datum point by offsetting a point along a direction
You can position a datum point by selecting a point on the model, selecting an offset
direction, and entering an offset distance. Abaqus/CAE creates the datum point by offsetting the point in the given direction by the given
distance.
The figure below shows an example of creating a datum point by offsetting a point along a
direction.
From the main menu bar,
selectToolsDatum.
The Create Datum dialog box appears. The dialog box outlines the
types of datum geometry you can create.
Abaqus/CAE displays prompts
in the prompt area to guide you through the procedure.
Tip:
You can also create a datum point using the tool, located in the module toolbox. For a diagram of the datum tools
in the toolbox, see Using the Datum toolset.
From the list of types at the top of the dialog box, choose Point.
The Method list indicates the methods you can use to create a
datum point.
From the Method list, select Offset from point in a
direction.
If desired, select Make Independent from the prompt area to create
the datum as an independent feature.
From the part or assembly in the current viewport, select a point.
Select a linear edge or datum axis for the direction..
The datum point appears. You cannot modify a datum point created with this method; you
must delete the old point and create a new one.
Press OK, or flip the direction.
In the text field in the prompt area, enter the value of the offset distance.
The datum point appears. You can modify the position of the datum point by selecting
Feature > Edit from the main menu bar and modifying the value of
the offset distance or flip direction.