Using the interaction editors

This section explains how to enter data in the interaction editor to define specific types of interactions.

• Defining general contact
• Specifying and modifying contact property assignments for general contact
• Specifying and modifying contact initialization assignments for general contact
• Specifying and modifying contact stabilization assignments for general contact
• Specifying surface property assignments for general contact
• Specifying contact formulation assignments for general contact
• Defining surface-to-surface contact
• Defining self-contact
• Specifying contact controls in an Abaqus/Standard analysis
• Specifying contact controls in an Abaqus/Explicit analysis
• Defining a fluid cavity interaction
• Defining a fluid exchange interaction
• Defining a fluid inflator interaction
• Defining a model change interaction
• Defining a Standard-Explicit co-simulation interaction
• Defining pressure penetration
• Defining acoustic impedance
• Defining incident waves
• Defining cyclic symmetry
• Defining foundations
• Defining a cavity radiation interaction
• Defining a surface film condition interaction
• Defining a concentrated film condition interaction
• Defining a surface radiative interaction
• Defining a concentrated radiative interaction
• Defining an actuator/sensor interaction
• Defining contact mass scaling