setValues(...)
This method modifies the ConstrainedSketchOptions object.
Required arguments
None.
Optional arguments
- constructionGeometry
A Boolean specifying whether construction geometry is shown. The default value is ON.
- gridSnap
A Boolean specifying whether the cursor snaps to the grid. The default value is ON.
- preselection
A Boolean specifying whether geometry will be preselected. The default value is ON.
- addImpliedConstraints
A Boolean specifying if implied constraints are added during sketching. The default value is ON.
- maxCoplanarEntities
An Int specifying the maximum number of coplanar entities which should be automatically projected from the background, when a sketch based feature is created or edited. When this value is exceeded no entities are automatically projected and a warning issued. Possible values are maxCoplanarEntities 0. The default value is 300.
- autoConstrainAngularTolerance
A Float specifying the angular tolerance in degrees which is used to determine parallel and tangential conditions during the auto-constrain operation. For example any two lines which have an angle smaller than the given autoConstrainAngularTolerance will be assumed to be parallel, and a parallel constrain may be added during the auto-constrain operation. The default value is 0.01.
- autoConstrainLinearTolerance
A Float specifying the linear tolerance which is used to determine when two points or geometries are coincident during the auto-constrain operation. The default value is 10–6.
- autoConstrainOptions
A sequence of SymbolicConstants specifying which type of constraints may be added by the auto-constraint tool. Possible values are PARALLEL, PERPENDICULAR, IDENTICAL, TANGENT, CONCENTRIC, and EQUALRADIUS. The default value is (PARALLEL,, PERPENDICULAR,, IDENTICAL,, TANGENT,, CONCENTRIC,, EQUALRADIUS).
- dragMethod
A SymbolicConstant specifying the constraint solving mode used by the sketcher during drag operation. Possible values are MINIMUM_MOVE, STANDARD, WEIGHTED, and RELAXATION. The default value is MINIMUM_MOVE.
- editMethod
A SymbolicConstant specifying the constraint solving mode used by the sketcher during regular sketch editing and adding new constraints and dimensions. Possible values are MINIMUM_MOVE, STANDARD, WEIGHTED, and RELAXATION. The default value is STANDARD.
Return value
None.
Exceptions
RangeError.