Specifying Design Responses in a Transient Dynamic Analysis

A transient dynamic adjoint design sensitivity analysis supports two kinds of design responses: node responses and element responses. The node responses refer to quantities such as displacements or reaction forces and moments at one or more nodes in the structure.

This page discusses:

You request design responses using a syntax analogous to that for specifying output requests to the output database. There are no default responses. If no responses are requested, no design responses and no sensitivities are output. Specifying a response outputs both the design response value and its sensitivities. You must specify a node set or an element set as part of a node or an element design response definition. If the set contains more than one entity (node or element), the design response contains the sum of the contributions from all of the entities in the set.

Optionally, you can specify one or more time points at which a physical quantity of interest is to be treated as a design response. If no time point is specified, the time point corresponding to the end of the step is used for the design response.

Input File Usage

Use the following options to request element design responses at a specific time point:

DESIGN RESPONSE, NAME=response name, TIME MARKS=YES, TIME POINTS=time point name
ELEMENT RESPONSE, ELSET=elset name

Use the following options to request node design responses at a specific time point:

DESIGN RESPONSE, NAME=response name, TIME MARKS=YES, TIME POINTS=time point name
NODE RESPONSE, NSET=nset name, ORIENTATION=orientation name

Each design response specification block must request only a single design response. Multiple design responses require multiple uses of the design response specification block, once for each response.

Restrictions on Responses

The tables below describe the available design responses for transient dynamic analysis.

Table 1. Node design responses for transient dynamic analysis.
Physical quantity Node response
Displacement components U1, U2, U3
Displacement magnitude UMAG
Rotation components UR1, UR2, UR3
Rotation magnitude URMAG
Translational velocity components V1, V2, V3
Translational velocity magnitude VMAG
Rotational velocity components VR1, VR2, VR3
Rotational velocity magnitude VRMAG
Translational acceleration components A1, A2, A3
Translational acceleration magnitude AMAG
Rotational acceleration components AR1, AR2, AR3
Rotational acceleration magnitude ARMAG
Reaction force components RF1, RF2, RF3
Reaction moment components RM1, RM2, RM3
Table 2. Element design responses for transient dynamic analysis.
Physical quantity Element response
Rate of internal work ELPF
Von Mises equivalent stress MISES
Signed von Mises equivalent stress S_MISES
Maximum principal stress SP3
Minimum principal stress SP1
Maximum principal strain EP3
Minimum principal strain EP1
Maximum principal logarithmic strain LEP3
Minimum principal logarithmic strain LEP1
Maximum principal nominal strain NEP3
Minimum principal nominal strain NEP1
Neuber equivalent stress NBSEQ
Glinka equivalent stress GKSEQ
Neuber equivalent strain NBEEQ
Glinka equivalent strain GKEEQ
Plastic strain magnitude PEMAG
Neuber equivalent plastic strain NBPEEQ
Glinka equivalent plastic strain GKPEEQ