*NORMAL

Specify a particular normal direction.

This option is used to define alternative nodal normals for elements. In an Abaqus/Standard analysis it can also be used to define alternative normals for contact surfaces.

This page discusses:

See Also
In Other Guides
Normal Definitions at Nodes
Beam Element Cross-Section Orientation

Products Abaqus/Standard Abaqus/Explicit

Type Model data

LevelPartPart instanceAssembly

Optional parameters

TYPE

Set TYPE=ELEMENT (default) to allow the alternative normal definition of elements.

Set TYPE=CONTACT SURFACE to allow the alternative normal definition of contact surfaces in an Abaqus/Standard analysis.

BEAM NORMAL

This parameter applies to beam elements only, and it can be used only with TYPE=ELEMENT.

Set BEAM NORMAL=RULE BASED (default) to use a rule-based approach to define nodal normals. In some situations, the specified nodal normals might be reversed.

Set BEAM NORMAL=FIXED to specify that nodal normals will be used as they are specified, without any rule-based reversal.

Data lines to define normals for elements (TYPE=ELEMENT)

First line
  1. Element number or element set label.

  2. Node number or node set label.

  3. First component of normal in global coordinates.

  4. Second component of normal in global coordinates.

  5. Third component of normal in global coordinates.

Repeat this data line as often as necessary to define the normals.

Data lines to define normals for contact surfaces (TYPE=CONTACT SURFACE)

First line
  1. Main surface name.

  2. Node number or node set label (on main surface).

  3. First component of normal in global coordinates.

  4. Second component of normal in global coordinates.

  5. Third component of normal in global coordinates.

Repeat this data line as often as necessary to define the normals.