*SOLVER CONTROLS

Specify controls for the iterative and direct linear solvers.

This option is used to set the control parameters for both the direct and iterative linear equation solvers.

This page discusses:

See Also
In Other Guides
Direct Linear Equation Solver
Iterative Linear Equation Solver

ProductsAbaqus/StandardAbaqus/CAE

TypeHistory data

LevelStep

Abaqus/CAEStep module

Optional parameters

CONSTRAINT OPTIMIZATION

Include this parameter to optimize the handling of hard contact and compressibility constraints associated with hybrid elements.

RESET

Include this parameter to reset all of the iterative solver controls to their default values. The option should have no data lines when this parameter is used.

If this parameter is omitted, only the iterative solver specified controls will be changed in the current step; the other controls will remain at their settings from previous steps.

Data line to define control parameters for the iterative solver

First (and only) line

  1. Relative tolerance for convergence. The default is 10−6 for all linear perturbation and general nonlinear procedures.

  2. Maximum number of iterations allowed. The default is 500.

  3. ILU factorization fill-in level. The default is 0; the maximum is 3. This parameter applies only to porous media (soils) analyses.