*REFLECTION

Define reflection symmetries for a cavity radiation heat transfer analysis.

This option is used to define a cavity symmetry by reflection through a line or a plane. It can be used only following the RADIATION SYMMETRY option.

This page discusses:

See Also
*RADIATION SYMMETRY
In Other Guides
Cavity Radiation in Abaqus/Standard

ProductsAbaqus/StandardAbaqus/CAE

TypeHistory data

LevelStep

Abaqus/CAEInteraction module

Required parameters

TYPE

Set TYPE=LINE to create a cavity composed of the cavity surface defined in the model and its reflection through a line. See Figure 1. This option can be used only for two-dimensional cases.

Set TYPE=PLANE to create a cavity composed of the cavity surface defined in the model and its reflection through a plane. See Figure 2. This option can be used only for three-dimensional cases.

Set TYPE=ZCONST to create a cavity composed by the cavity surface defined in the model and its reflection through a line of constant z-coordinate. See Figure 3. This option can be used only for axisymmetric cases.

Data line to define reflection of a two-dimensional cavity (TYPE=LINE)

First (and only) line

  1. X-coordinate of point a (see Figure 1).

  2. Y-coordinate of point a.

  3. X-coordinate of point b.

  4. Y-coordinate of point b.

Data lines to define reflection of a three-dimensional cavity (TYPE=PLANE)

First line

  1. X-coordinate of point a (see Figure 2).

  2. Y-coordinate of point a.

  3. Z-coordinate of point a.

  4. X-coordinate of point b.

  5. Y-coordinate of point b.

  6. Z-coordinate of point b.

Second line

  1. X-coordinate of point c.

  2. Y-coordinate of point c.

  3. Z-coordinate of point c.

Data line to define reflection of an axisymmetric cavity (TYPE=ZCONST)

First (and only) line

  1. z-coordinate of symmetry line (see Figure 3).

Figure 1. REFLECTION, TYPE=LINE option.

Figure 2. REFLECTION, TYPE=PLANE option.

Figure 3. REFLECTION, TYPE=ZCONST option.