CapPlasticity object

CapPlasticity(...)

This method creates a CapPlasticity object.

mdb.models[name].materials[name].CapPlasticity
session.odbs[name].materials[name].CapPlasticity

table: A sequence of sequences of Floats specifying the items described below.

temperatureDependency: A Boolean specifying whether the data depend on temperature. The default value is OFF.
dependencies: An Int specifying the number of field variable dependencies. The default value is 0.

Material cohesion, $d$ , in the $p$ – $t$ plane (Abaqus/Standard) or in the $p$ – $q$ plane (Abaqus/Explicit).
Material angle of friction, $β$ , in the $p$ – $t$ plane (Abaqus/Standard) or in the $p$ – $q$ plane (Abaqus/Explicit). Give the value in degrees.
Cap eccentricity parameter, $R$ . Its value must be greater than zero (typically 0.0 $< R <$ 1.0).
Initial cap yield surface position, ${ε_{v o l}^{p l} |}_{0}$ .
Transition surface radius parameter, $α$ . The default value is 0.0 (i.e., no transition surface).
(Not used in Abaqus/Explicit) $K$ , the ratio of the flow stress in triaxial tension to the flow stress in triaxial compression. Possible values are 0.778 $\leq K \leq$ 1.0. If the default value of 0.0 is accepted, Abaqus/Standard assumes $K = $ 1.0.
Temperature, if the data depend on temperature.
Value of the first field variable, if the data depend on field variables.
Value of the second field variable.
Etc.

A CapPlasticity object.

RangeError.

This method modifies the CapPlasticity object.

None.

The optional arguments to setValues are the same as the arguments to the CapPlasticity method.

None.

RangeError.

The CapPlasticity object has members with the same names and descriptions as the arguments to the CapPlasticity method.

In addition, the CapPlasticity object can have the following members: