Using the load editors

This section explains how to enter data in the load editor to define specific types of loads.

The following topics are covered in Modeling techniques:

• Bolt loads

• Creating the submodel load

• Defining a concentrated force
• Defining a moment
• Defining a pressure load
• Defining a shell edge load
• Defining a surface traction load
• Defining a pipe pressure load
• Defining a body force
• Defining a line load
• Defining a gravity load
• Defining a generalized plane strain load
• Defining a rotational body force
• Defining a Coriolis force
• Defining a connector force
• Defining a connector moment
• Defining a substructure load definition to activate a substructure load case
• Defining an inertia relief load
• Defining a surface heat flux
• Defining a body heat flux
• Defining a concentrated heat flux
• Defining an inward volume acceleration
• Defining a concentrated pore fluid flow
• Defining a surface pore fluid flow
• Defining a concentrated current
• Defining a surface current
• Defining a body current
• Defining a surface current density
• Defining a body current density
• Defining a concentrated charge
• Defining a surface charge
• Defining a body charge
• Defining a concentrated concentration flux
• Defining a surface concentration flux
• Defining a body concentration flux
• Defining a fluid pressure penetration load