Products
Abaqus/Standard
Abaqus/CAE
Type
History data
LevelStep
Abaqus/CAE
Step module
Optional parameters
-
DELTMX
- Include this parameter to activate automatic time incrementation
in a transient analysis.
Set this parameter equal to the maximum
temperature change allowed in an increment in a transient analysis. Abaqus/Standard restricts the time step to ensure that this value is not exceeded at
any node (except nodes with boundary conditions) during any increment of
the analysis.
If the maximum allowable temperature change is not
specified, there is no restriction on the maximum temperature change in
an increment.
-
STEADY STATE
- Include this parameter to choose a steady-state thermal analysis.
Automatic time incrementation is used in this case.
If this parameter is
omitted, transient thermal analysis is assumed.
-
THERMAL RUNAWAY
-
Include this parameter to activate thermal runaway in a coupled
thermal-electrochemical analysis.
If this parameter is omitted, the step solves for all fields defined in
an electrochemical analysis. If this parameter is included, the step
does not solve for the electrochemical fields, ion concentration, and
electric potential in the fluid phase.
Data line to define incrementation
- First (and only)
line
-
Initial time increment. If automatic incrementation is
used, this value should be a reasonable suggestion for the
initial step and is adjusted as required. If direct
incrementation is used, this value is the fixed time increment
size.
Total time period.
Minimum time increment allowed. If Abaqus/Standard finds it needs a smaller time increment than this value, the
analysis ends. If a value is given, Abaqus/Standard uses the minimum of the given value and 0.8 times the initial
time increment. If no value is given, Abaqus/Standard sets the minimum increment equal to the minimum of 0.8 times
the initial time increment (first data item on this data line)
and 10−5 times the total time period (second data
item on this data line). This value is used only for automatic
time incrementation.
Maximum time increment allowed. If this value is not
specified, the upper limit is the total step time. This value is
used only for automatic time incrementation.