*ADAPTIVE REMESH RETAIN

Specify mesh or mesh geometry entities that need to be reconstructed in the adaptive domain.

This option is used to specify the mesh and/or mesh geometry entities in the adaptive subdomain of a model that need to be reconstructed after each remeshing operation. It must be used in conjunction with the ADAPTIVE REMESH option.

This page discusses:

See Also
*ADAPTIVE REMESH
In Other Guides
Fatigue Crack Propagation with Adaptive Remeshing

Products Abaqus/Standard

Type Model data

LevelThis option is not supported in a model defined in terms of an assembly of part instances.

Required parameters

TYPE

Set TYPE=POINT to specify node sets containing a group of discrete nodes that need to be retained in the adaptive subdomain of a model. This option is typically used to reconstruct node sets containing a group of discrete nodes with prescribed boundary conditions, concentrated loads, nodal transformations, constraints, or output requests, after each adaptive remeshing operation. Only the node sets listed here are retained.

Set TYPE=VOLUME to specify element sets that need to be retained in the adaptive subdomain of a model. This option is typically used to preserve regions (material volumes) and reconstruct element sets corresponding to different section definitions; to apply volume-based loads, such as gravity; to apply node-based constraints (multi-point constraints, displacement boundary conditions); or to request nodal output on a cloud of nodes over a certain material volume following each adaptive remeshing operation. Only the element sets listed here are retained.

Set TYPE=SURFACE to specify surfaces that need to be retained in the adaptive subdomain of a model. This option is typically used to preserve and reconstruct surfaces for the application of constraints or distributed loads; to request output; and to associate mesh entities (node sets) to mesh geometry entities (edges/surfaces) in the adaptive subdomain following each adaptive remeshing operation. Surfaces not listed here are assumed to be outside of the adaptive subdomain.

Data lines to specify the mesh and mesh geometry entities that need to be reconstructed in the adaptive subdomain for TYPE=POINT

First line
  1. List of node sets, each containing a group of discrete nodes, in the adaptive subdomain that need to be retained following each remeshing operation.

Repeat this data line as often as necessary to specify the node sets that need to be retained. Up to 16 node sets can be listed per line.

Data lines to specify the mesh and mesh geometry entities that need to be reconstructed in the adaptive subdomain for TYPE=VOLUME

First line
  1. List of element sets in the adaptive subdomain that need to be retained following each remeshing operation.

Repeat this data line as often as necessary to specify the element sets that need to be retained. Up to 16 element sets can be listed per line.

Data lines to specify the mesh and mesh geometry entities that need to be reconstructed in the adaptive subdomain for TYPE=SURFACE

First line
  1. List of surfaces in the adaptive domain that need to be retained following each remeshing operation.

Repeat this data line as often as necessary to specify the surfaces that need to be reconstructed. Up to 16 surfaces can be listed per line.