Display the ion concentration boundary condition editor using one of the
following methods:
To create a new ion concentration boundary condition, follow the
procedure outlined in Creating boundary conditions
(Category:
Electrical/Magnetic/Electrochemical;
Types for Selected Step:
Ion concentration).
Select an analytical field to define a spatially varying boundary
condition. Only analytical fields that are valid for this boundary
condition type are displayed in the selection list. Alternatively,
you can click
to create a
new analytical field. (See The Analytical Field toolset for
more information.)
The Distribution option appears in the editor only if you
are creating the boundary condition or editing the boundary condition in the
step in which it was created. This option is unavailable if you select the
Fixed at current magnitude method.
If you selected the Uniform or analytical field
distribution option, perform the following steps:
If applicable, enter the magnitude of the ion concentration in the
Magnitude field.
If applicable, click the arrow to the right of the
Amplitude field, and select the amplitude of
your choice from the list that appears. Alternatively, you can click
to create a new
amplitude. (See The Amplitude toolset for more
information.)
Note:
The Magnitude and
Amplitude fields are unavailable if you
are creating the boundary condition in the initial step (in
which case the magnitude is always zero) or are fixing the
magnitude at its final value from the previous general step.
Click OK to save your data and to exit the editor.
If you selected the User-defined distribution option,
perform the following steps:
If desired, enter the ion concentration magnitude in the
Magnitude field. Magnitude data that you enter
in the editor are passed into the user subroutine.
(The Magnitude field is unavailable if you are
creating the boundary condition in the initial step.)
Click OK to save any entered data and to exit the
editor.
In the job editor, click the General tab, and
specify the file containing the user subroutine that defines the
boundary condition. For more information, see Specifying general job settings.
Note:
You can specify only one user subroutine file in the job editor;
if your analysis involves more than one user subroutine, you
must combine the user subroutines into one file and then specify
that file.