Products
Abaqus/Standard
Abaqus/Explicit
Abaqus/CAE
Type
Model data
LevelModel
Abaqus/CAE
Property module
Required parameters
-
NAME
-
Set this parameter equal to a label to use to refer to the material in the element
property options. Material names in the same input file must be unique. Furthermore,
material names should be unique from the names associated with property definitions
such as CONNECTOR BEHAVIOR and FLUID BEHAVIOR. Material names
adhere to the naming convention for labels (see Input Syntax Rules), except
that they cannot begin with a number.
Optional parameters
-
RTOL
-
This parameter applies only to Abaqus/Explicit analyses.
Set this parameter equal to the tolerance to use for regularizing the material data.
The default is
RTOL=0.03.
-
STRAIN RATE INTERPOLATION
-
This parameter applies only to Abaqus/Explicit analyses and is used only to interpolate strain rate–dependent material data.
Set
STRAIN RATE INTERPOLATION=LOGARITHMIC
(default) to use logarithmic intervals while interpolating strain rate–dependent
material data.
Set
STRAIN RATE INTERPOLATION=LINEAR
to use linear intervals while interpolating strain rate–dependent material data.
-
USER TYPE
-
Set this parameter equal to the name of the material user type that identifies a
special-purpose material modeling technique. For more information, see About Special-Purpose Material Modeling Techniques.
Optional and mutually exclusive parameters in Abaqus/Explicit
-
SRATE FACTOR
-
Set this parameter equal to the factor used to filter the equivalent plastic strain
rate for the evaluation of strain rate-dependent material data.
The default value is 0.9, unless a time filter is
defined with the SRATE TIME
parameter.
-
SRATE TIME
-
Set this parameter equal to the time constant used to filter the equivalent plastic
strain rate for the evaluation of strain rate-dependent material data.
There are no data lines associated with this option.