Elements tested
- AC1D2
- AC1D3
- ACAX3
- ACAX4
- ACAX4R
- ACAX6
- ACAX8
- AC2D3
- AC2D4
- AC2D4R
- AC2D6
- AC2D8
- AC3D4
- AC3D5
- AC3D6
- AC3D8
- AC3D8R
- AC3D10
- AC3D15
- AC3D20
ProductsAbaqus/StandardAbaqus/Explicit Elements tested
Problem descriptionThe meshes used for the acoustic element patch tests are the same as those used for the corresponding heat transfer elements. Note:
The models are analyzed via steady-state dynamic procedures in which a small frequency, 0.01 Hz, is requested. In Abaqus/Explicit the steady-state results are obtained by performing a long-term transient simulation. Boundary conditions:, where P is the acoustic pressure, through are arbitrary constants, and x, y, z denote spatial location. Acoustic pressures (DOF 8) are prescribed at every node along the boundary of the mesh. Reference solutionIt is currently not possible to report the pressure gradients for acoustic elements in Abaqus. However, it is possible to compare the acoustic pressures at the interior nodes of the mesh to the values that are analytically calculated from the above expression for P. Results and discussionAll elements yield exact values of P at the interior nodes of the models. Input filesAbaqus/Standard input files
Abaqus/Explicit input files
|