*HYSTERESIS

Specify a rate-dependent elastomer model.

This option is used to specify the creep part of the material model for the hysteretic behavior of elastomers.

This page discusses:

See Also
In Other Guides
Hysteresis in Elastomers

ProductsAbaqus/StandardAbaqus/CAE

TypeModel data

LevelModel

Abaqus/CAEProperty module

There are no parameters associated with this option.

 

Data line to define the creep behavior

First (and only) line

  1. Stress scaling factor, S.

  2. Creep parameter, A.

  3. Effective stress exponent, m.

  4. Creep strain exponent, C.

  5. Constant, E, for regularizing the creep strain rate near the undeformed state. The value of E should be non-negative. If this field is left blank, the default value of 0.01 is used.

Typical values of these parameters for common elastomers are given in Hysteresis in Elastomers.