ABQ_AM_EigenStrain_TrajectoryBased_Activation

This parameter table type is used in special-purpose techniques for additive manufacturing.

This page discusses:

See Also
Special-Purpose Techniques for Additive Manufacturing

ProductsAbaqus/Standard

You must include a parameter table of type "ABQ_AM_EigenStrain_TrajectoryBased_Activation" in the table collection. Only one set of data must be defined.

Tables of type "ABQ_AM_MaterialDeposition", "ABQ_AM_MovingHeatSource", and "ABQ_AM_EigenStrain_TrajectoryBased_Activation" cannot refer to the same event series in an analysis.

Parameter Table Type Definition

PARAMETER TABLE TYPE,NAME="ABQ_AM_EigenStrain_TrajectoryBased_Activation", PARAMETERS=5
 STRING, " ", "Deposition Head Event Series", , ,
 STRING, "Z", "Stack Direction", , "X|Y|Z",
 FLOAT, "1.0", "Bead Height", , ,
 FLOAT, "1.0", "Bead Width", , ,
 STRING, "Below", "Deposition Position", , "Below|Middle|Above",

Parameters

Deposition Head Event Series
Name of an event series of type "ABQ_AM_HeatSourceTrajectory_RuleID" describing the trajectory of the toolpath.
Stack Direction
Direction of progressive material deposition layers. Options are “X”, “Y”, and “Z” indicating the global xg-, yg-, or zg-direction, respectively.
Bead Height
Height (measured parallel to the stack direction) of the deposited bead of material.
Bead Width
Width (measured perpendicular to the stack direction) of the deposited bead of material.
Deposition Position
Set to "Above", "Middle", or "Below" to indicate that the deposited material bead is situated above, through, or below the path in the stack direction.