Manipulating the Graph Data

You can manipulate the data shown on the Graphs subtab. Selecting these options changes only the graphs on the subtab.

  1. Double-click the Data Matching component icon .
    The Data Matching Component Editor appears.
  2. From the Data Matching Component Editor, click the Simulation tab.
  3. Click the Graph subtab, and set any of the following options:
    OptionDescription
    Show only data in bounds Sets the graph to show only the curve that is between the filter lines.
    Show the target data Shows the target data when viewing the simulation data so you can compare them visually.
    Plot interpolated data Draws the curves in the graphs to reflect the interpolation that you selected.
  4. Click OK to save your changes and to close the Data Matching Component Editor.